Liquid can feed into your timepiece a lot of different ways. If you leave your way lying around, or on the table, someone might have spilled water on it. If you tend to keep your watch around your wrist, you may have bumped the crown or one of the some other buttons letting liquid in. perchance you're timekeeper says water resistant on it, meaning it may not in truth be fully liquid proof. It may be too late to keep your ticker from getting wet, but these steps will help you get liquid out of your watch.

Study the back of your watch-- Look carefully at the back of your watch. To get the liquid out of your watch, you will want to take off the back of your watch. It sounds like a rugged activity, but it's in reality rather easy. Taking the back off of your watch shouldn't take more than a few minutes.

Before you proceed-- It's a good thought to confabulate your warranty. While most of the time you can get the water out of your timekeeper by yourself, sometimes removing the rear of your timekeeper, or taking pieces apart can void the warranty. It's a great idea to confer with your warranty for the watch before you continue. If you have an expensive watch, it may just be a good idea to take it in and get it fixed. A store can normally take apart your timekeeper and get the water out of your watch for just about $50 depending on the watch .

Your local watch carrier may have watch tools for purchase It's a good idea to have the watch tool before proceeding

Find the tools-- To get the water out of your watch you want to have the exact tools to take off the side of the timepiece. Some watches only require a small phillips screw driver, which you may have to special order. One type of watch may have a single screw in the center of the back plate of the watch. Another variety will have four screws around the boundary of the watch. The Most found type of watch has no screws, but a smooth back plate. This will necessitate a specific watch tool, or a flathead screwdriver if you're courageous.

Take off the back of your watch-- It seems easy enough, but it can be a slippery procedure. Look for the indent around the edge of the plate of the watch. Insert your watch tool, or flathead screwdriver into the smaller indent in the watch. Carefully pry off your back plate of the watch. Now that you have the back of thewatch off, you can begin to transmit the water out of your watch.

Touch it dry-- acquire a paper towel and pat the inside of the watch dry. Be sure when you get liquid out of the watch not to change any of the complex pieces interior. Just cautiously pat it with a paper piece of material to take out any left over liquid that is in the watch.

permit it dry-- You've done what your skill can do now. It's time to allow the watch dry overnight. The liquid will have a opportunity to vaporize if you leave the watch with the back side facing up and leave it overnight. This is the most effectual thing you can do to get water out of your watch.