Lighting your gas fire place is crucial to be able to encounter the warmth and splendor that they can provide. In contrast to a traditional timber burning up fireplace, a gas fire place is normally self-starting. Different from an electric powered fireplace, a gas fireplace requires usage of a pilot light in order to ignite, a lot like water heater or a gas stove.

Try looking in your fire place to find out if you notice a tiny flame, which is called the initial light. If you do not see this particular flame, then you should first light the pilot before you can fire up your gas fireplace.

If you have an attractive front panel or grill on your gas fire place, always take it off before lighting your pilot. Your valves may be positioned at the rear of a panel. In that case, locate this particular panel and open it in order to access your valves and buttons. Make certain all your controls are off and the pilot is really off.

Double check to be sure that the control valve and main gas valve are turned off. In case the main gas valve or control valve is on, switch it off and hold on no less than five minutes to permit any gas to clear before you carry on. These kinds of crucial actions will allow you to avoid mishaps with your gas fireplace. Take away any interior glass doors if you haven't already done this.

Smell throughout the fire place to make certain that there isn't any gas present that may ignite when you start the pilot. Be sure you sniff around near the flooring as the gas is heavier than the surrounding air. If there is, allow the fire place to air out at least 5 minutes before you continue. In case the gas smell does not clear and you've checked out once again to ensure that all of the valves are shut off, you'll want to call a technician to see if there are any leaks.

If there isn't any gas smell present, turn the main valve on and the control valve to pilot. Press the control valve in about one-fourth of an inch as you are turning. If you cannot press the control valve inward using just your hand, contact a certified technician. Do not use any kind of equipment to attempt to press the control valve. Forcing the valve isn't just a fire hazard, but might also lead to explosion.

Press the pilot valve in at least 15 seconds but up to thirty seconds and push the piezoelectric spark igniter many times in an interval of once for every second to turn the pilot light on. Once the pilot light is turned on, a small flame should show up. If the pilot light won't stay on after repeated attempts, phone a qualified technician.

Hold the pilot valve in for one minute or more to warm up your thermopile. When the thermopile has been heated up, your burner will activate. When burner is turned on, switch the control valve to on and adjust the thermostat to your selected settings. The thermostat control might be a turn in the bottom panel, a standard light switch, dimmer, or it may be started utilizing a remote device.

Replace the inner glass door, any bottom access panel, elaborate glass panel or grill and make certain it's securely clamped to the front of your fireplace. Enjoy your fireplace!